Removing paint protection film can be a tedious task, but by following these step-by-step instructions, you can easily get through the process.
Step 1: Gather your materials.
Before you begin, make sure you have all the necessary materials on hand. You will need a heat gun or hair dryer, a plastic razor blade, rubbing alcohol, microfiber towels, and a spray bottle filled with soapy water.
Step 2: Heat the film.
Start by heating the film with the heat gun or hair dryer. This will soften the adhesive and make it easier to remove. Be careful not to overheat the film, as this could damage your car's paint.
Step 3: Peel back the film.
Once the film is heated, use the plastic razor blade to carefully peel back a corner of the film. Slowly peel back the film, applying heat as needed to soften the adhesive. Be patient and take your time to avoid tearing the film.
Step 4: Remove any leftover adhesive.
After the film is removed, you may have some leftover adhesive stuck to the surface of your car. Spray rubbing alcohol onto a microfiber towel and gently rub the adhesive until it comes off. You can also use a plastic razor blade to scrape off any stubborn adhesive.
Step 5: Clean the area.
Once all the film and adhesive are removed, spray the area with the soapy water and wipe it clean with a microfiber towel. This will remove any remaining residue and leave your car looking like new.
By following these simple steps, you can easily remove paint protection filmremove paint protection film from your car without causing any damage. Remember to take your time and be patient throughout the process to ensure a successful removal.
For more custom adhesive film for large orders, stainless steel protective filminformation, please contact us. We will provide professional answers.