Straight into the wire drawing machine operating procedures
Straight into the wire drawing machine operating procedures
1、Before driving, check whether the equipment air pressure is enough, whether the cooling water circulation system is smooth, whether there is any debris on the motor belt and reel, and whether the safety facilities are sensitive and effective.
2、According to the requirements of the drawing process will be qualified billet wire loaded into the payoff frame.
3, first of all, the wire rolling head, guide it through the lubricant-filled mold box, into the first drawing die.
4、After passing through the drawing die, use the wire puller to wind the wire around the reel for several times, then click the foot switch to make the wire accumulate a certain number of laps on the working surface of the reel, and then loosen the wire to be ready to wear into the second drawing die.
5、All threading methods are the same as above, and so on, so that the wire around each reel and pull tight, threading operation is completed. 6、Wire in slow speed through the various volumes of Jane, first of all, the wire will be wound up to the take-up machine I-beam wheel, all the reels of the "input / cut off" switch to the "input" position. Set the "input/cut-off" switch of all reels to the "input" position.
7、According to the product requirements to set the meter value, and will meter reset.
8、Finally set the required drawing speed on the operation table.
9、Press the start button, the equipment began to normal drawing.
10, in the drawing process, should pay attention to the wire lubrication is sufficient, die box cooling water is sufficient. It is strictly prohibited to open the machine guard to start the machine.